有源滤波器的设计毕业设计论文.doc

  1. 1、本文档共32页,可阅读全部内容。
  2. 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
  3. 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  4. 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
篇优秀的毕业设计论文,可为大学生本专业本院系本科专科大专和研究生学士硕士相关类学生提供毕业论文范文范例指导也可为要代写发表职称论文的提供参考范本另本网本文文中有关的摘要开题报告致谢

学号: 08033160120 毕业论文 有源电力滤波器设计 Active power filter design 学院:电信学院 专业:电气自动化技术 班级:电气专081 学生: 李 昂 指导教师(职称): 罗如山老师 完成时间 2011 年 05 月 5 日至 2011 年 月 日 目 录 摘 要 1 ABSTRACT 2 第一章 谐波产生的机理及其治理 3 1.1谐波产生的机理 3 1.2谐波的治理 4 第二章 有源电力滤波器的谐波检测及控制策略 5 2.1 有源电力滤波器的谐波检测 5 2.1.1 瞬时无功功率理论 5 2.1.2 三相电路谐波和无功的检测 7 2.2 有源电力滤波器的控制策略 10 2.2.1 有源电力滤波器补偿电流的控制 10 2.2.2 主电路直流侧电压的控制 12 第三章 并联型有源电力滤波器的硬件设计 13 3.1 系统结构 13 3.2 主电路设计 14 3.2.1 主电路参数设计 14 3.2.2 开关器件的选取 15 3.3 控制电路设计 16 3.3.1 控制电路结构 16 3.3.2 DSP芯片简介 17 3.4 检测与调理电路设计 19 3.4.1 电流信号检测调理电路 19 3.4.2 电压信号检测调理电路 20 3.4.3 采样触发信号提取电路 20 第四章 并联型有源电力滤波器的系统仿真 22 4.1 并联型有源电力滤波器检测系统仿真 22 (1)仿真模型的建立 22 (2)仿真结果 22 (3)结果分析 23 4.2 并联型有源电力滤波器控制系统仿真 24 (1)仿真模型的建立与参数选取 24 (2)仿真结果 24 (3)系统谐波分析 25 结束语 26 参考文献 27 摘 要 ABSTRACT With the rapid development of electric power and electronic technology, non-linear load have been widely used, the harmonic makes increasing serious impact against the electric network, if unchecked, it will seriously affect the entire electric network, therefore, the harmonic compensation has become much more important. APF is a new harmonic and dynamic reactive compensation devices, compare with the traditional passive LC filter, APF has the advantages of fast response, good compensation and dynamic compensation. This article summarizes the harmonic mechanism and management, and discussed the structure and active power filter works. From depth depth-study of the detection of harmonic and reactive current for APF , we analysis the p-q method and ip-iq method based on the instantaneous reactive power theory, because of the superiority of ip-iq method, we selected it as harmonic detection. we in-depth analysis the control strategy for APF, determine the hysteres is control method used to control the compensation current. In the pager we introduced DSP chip TMS320F2812. On this basis, I devices APF. After, I use of its MATLAD7.0 are simul

文档评论(0)

毕业论文 + 关注
实名认证
内容提供者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档