300吨水泥制品压力机说明书.doc

300吨水泥制品压力机 摘要 目前，液压压力机被广泛用于各个领域。技术也在不断地更新。要解决控制问题，只从机械和液压角度来考虑很难使产品有质的飞跃，必须引入良好控制性能和信息处理能力的电子技术或电业转换技术。我设计的 “300吨液压压力机”正是应用了电和液的混合技术。 该设计分为液压部分和主机部分。文中首先简要的概括了液压机的相关知识及发展前景，接着详细的阐述了液压机液压系统的原理和设计，从工况分析到确定系统的主要参数，重点设计了液压缸。（主要尺寸，活塞和活塞杆，缓冲装置、排气装置等）。在这些设计的基础上，选择了液压元件及对系统进行验算。 其次，主机部分设计了液压机的主要部件（上横梁、活动横梁、工作台、立柱）的尺寸，机架的强度和刚度的校核。 接着，对液压机过载问题做了一些简单的陈述。 最后，对本设计进行了总结。 关键词：压力机过载 电液位置控制 液压机 液压系统 液压缸 电液转换技术 300 tons of cement products hydraulic press The abstract At present, hydraulic press has been widely used in various fields. Technology also in constant updates. To solve the problem, just from the control of mechanical and hydraulic pressure Angle to consider to make products have a qualitative leap, must introduce good control performance and the information processing capability of electronic technology or electric power conversion technology. I designed 300 tons of hydraulic press is the application of electric and hydraulic hybrid technology. This design is divided into hydraulic parts and main part. The paper firstly summarizes related knowledge of hydraulic and development prospects were described in detail, and then press hydraulic system, working principle and design from the analysis of the main parameters of the system to determine the key design, the hydraulic cylinder. (main dimensions, piston, piston rod and buffering device, exhaust device, etc.). In the design, and on the basis of the choice of system and hydraulic components. Secondly, the main part of the main components of hydraulic design (beam, and the size of the worktable, column), frame of the strength and stiffness of the check.Then, the problem of hydraulic overloading do some simple statements. Finally, this design was summarized. Keywords: press electro-hydraulic position control hydraulic overloading hydraulic system of hydraulic cylinder electro-hydraulic conversion technology 目录 摘要 I The abstract II 第1章 绪论 1 1.1液压压力机介绍 1 1.2液压机的特点 2 1.3电液比例控制技术 3 1.3.1电液比例控制技术概述 3 1.3.2电液比例控制技术的特点 4 1.3.3电液