系泊试验大纲导航设备.doc

Navigation equipment 导航设备 General 1. 总则 Check the following equipment and cables to see if they are correctly and completely installed and properly earthed. Check the insulation of the following equipment by each instrument manual. Measure the insulation resistance of antennas of following equipment which to be not less than 1M(. Note: Measure the semiconductor circuits by instrument which makers supply(=0.3 M(). (4) Equipment operator function shall finished during HAT. If it need adjust during SAT. （1）检查下列设备及电缆安装的正确性、完整性及接地的可靠性。 （2）用仪器检查下列设备的绝缘性。 （3）测量各设备无线的绝缘电阻，不小于1M(。 注：半导体电路按制造厂提供仪表测量(不小于0.3 M()。 (4) 设备的操作性试验在码头完成，如果需要额外的调整，将在试航初期完成。 1.1 Gyro compass 1.1.1 Check the starting settling time of gyrocompass. 1.1.2 Check alarm function for power failure. 1.1.3 Check the base line of master compass each repeater stand. The error of master compass to be less than 1(. 1.1.4 The gyro compass and all gyro repeaters zero adjusting to be carried out before leaving the port. The max deviation to be within ?.5? It is performed that read gyro compass and deviation to be adjusted and compare between gyro compass and qumagnetic compass after magnetic compass calibration at sea trial and adjust the deviation. Validate for gyro compass should be compared with marks which indicated on the chart. 1.1电罗经 1.1.1检查电罗经起动稳定时间。 1.1.2检查电罗经交流电源故障报警功能。 1.1.3检查主罗经和每个分罗经的航向标志线。主罗经误差小于1度。 1.1.4离港前首先对电罗经和所有分罗经校正。允许误差(0.50。 试航时，调整磁罗经并比较其与电罗经的偏差。 电罗经的验证应该与海图上的指示标记校对。 1.1.5 Gyrocompass N°1 calibrated verification: 1. 1.5 #1电罗经校准效用试验: 1.1.6 Gyrocompass N°2 calibrated verification: 1. 1.6 #2电罗经校准效用试验: 1.1.7 Gyrocompass N°3 calibrated verification: 1. 1.7 #3电罗经校准效用试验: 1.1.8 overhead after analog repeater compass(type:133-556) calibrated verification: 1. 1.8 后仪表板模拟罗经复示器(type:133-556)校准效用试验: 1.1.9 bridge wing port analog repeater compass(type:133-407) calibrated verification: 1. 1.9 左翼模拟罗经复示器(type:133-407)校准效用试验: 1.1.10 bridge wing STB analog repeater compass(type:133-407) calibrated verif