毕业论文--基于SPCE061A的模拟交通灯硬件驱动模块设计.docVIP

基于SPCE061A的模拟交通灯硬件驱动模块设计 完成日期： 指导教师签字： 答辩小组成员签字： 基于SPCE061A的模拟交通灯硬件驱动模块设计 摘要 近年来，城市化进程和社会经济得到了飞速发展。在此影响下，城市交通需求与机动车辆迅速增加，交通堵塞情况日益严重，大气和噪音污染呈上升趋势，恶性交通事故频发。交通问题成为困扰许多大城市发展的通病，交通拥堵成为制约城市经济和社会发展的“瓶颈”。建设方便、安全、高效率、低公害、有利于生态和环境保护、以公共交通为主体的多元化城市交通系统成为交通建设的新目标。通过改善交叉口交通信号灯控制从而缓解交通拥堵问题已迫在眉睫。 本方案利用SPCE061A为主控制器，配合交通灯模组V3.0设计的交通灯控制系统。该系统在适当的时候控制点亮绿色、黄色或者红色的LED灯，示意行人或者车辆可以通行或者不可以通行；另外通过数码管倒计时，示意车辆或者行人不可以通行时需要等待的时间或者通行时还有多少的剩余时间。 关键词：交通信号灯；SPCE061A；交通灯模组Hardware Drivers Based on Traffic Lights SPCE061A Design Abstract In recent years, urbanization has been rapid social and economic development. In this under the influence of urban transport demand and the rapid increase of motor vehicles, traffic congestion is becoming more serious, air and noise pollution is rising, vicious frequent traffic accidents. Traffic problems as the development of a common problem that plagues many large cities, traffic congestion as a constraint to urban economic and social development of the bottleneck. Construction of convenient, safe, high efficiency, low pollution, is conducive to ecological and environmental protection, to the diversification of public transport as the main urban transport system to become the new target of transportation construction. By improving the intersection traffic lights to ease traffic congestion is imminent. Use SPCE061A as the primary controller for this programme, Module V3.0 meet traffic lights traffic lights control system design. Control point at the proper time of the system of