薄木贴面工艺对板件翘曲度影响.pdfVIP

研究与设计 2006年第5期 薄木贴面工艺对板件翘曲度的影响 申利明，路则光，黄河浪，吴新凤，陈秀兰，薛丽丹 ( 南京林业大学木材工业学院，南京 210037 ) 摘要： 以红橡、硬枫和黑胡桃薄木和杨木多层板为材料，根据影响薄木饰面家具板件翘曲度的工艺因素，对添 5 加剂、涂胶量、热压压力、热压温度、热压时间5因素进行4水平的L (4 )正交试验，从薄木的木材学特性角度 16 对翘曲度的差异进行了分析，用极差分析法对影响翘曲度的工艺因素进行了剖析。研究表明，对红橡贴面板的 翘曲度而言，涂胶量是影响最大的因素；对于硬枫，涂胶量是最大的影响因素；对于黑胡桃，热压温度是最大 的影响因素。 关键词： 薄木；工艺参数；翘曲度；饰面家具 中图分类号： 文献标识码： 文章编号： TS653 A 1001-036X（2006）05-0018-03 Influence of the technological parameters upon the warp degree of poplar plywood for veneered furniture SHEN Li-ming, LU Ze-guang, HUANG He-lang, WU Xin-feng CHEN Xiu-lan, XUE Li-dan (College of Wood Science and Technology, Nanjing Forestry University, Nanjing 210037, China) 5 Abstract: According to the technological paramefers, making the L 16(4 ) orthodoxy-corrected test by added-material and adhesive content and unit press and temperature and time of hot press which affect the warp degrees of veneered furniture of poplar. Analysing the warp degree from wood characters and studying the processing parameters that affect the warp degrees by the difference method and modes. The result shows that adhesive content is vital, temperature is minor and the added material is little to the warp degrees of red-oak-veneered parts. But the adhesive content is vital, the hot time is minor and the press is little to the warp degrees of maple-veneered parts, and the time is vital, the adhesive content is minor and the press is little to the warp degrees of maple-veneered