CCNA交换机基本配置.pptVIP

目标 当你完成本章，你将可以： 检测设备的默认配置，实现交换机的基本配置 配置交换机的管理地址和默认网关 根据不同的网络实现二层交换机的添加移动 复习 使用SHOW命令可以检查交换机是否在出厂默认设置状态 配置交换机IP地址的命令和默认网关的命令 半双工使用冲突检测，全双工不需要进行冲突检测 MAC地址包括动态，永久和静态地址 Layer 2 of 2 Note: The 1900en maximum MAC address table size is 1024. Once the table is full, it will flood all new addresses until existing entries age out. The command to change the MAC address table aging time is as follows: wg_sw_a(config)#mac-address-table aging-time ? 10-1000000 Aging time value The default is 300 sec. The MAC address table is also referred to as the CAM table (Content Address Memory) on some switches. L