《路由器及其配置》实验报告.docVIP

《路由器及其配置》实验结果文件 实验名称 路由器基本配置 实验小组 第 7 组 组长 张碧波 成员名单 张碧波 许金皓 李松艳 刘晓萍 孙萌萌 朱晓 王玉勤 夏战辉 成员分工 路由器A 夏战辉 张碧波 许金皓 路由器B：李松艳 刘晓萍 孙萌萌 朱晓 王玉勤 完成情况 未完成原因 实验成绩 附：实验配置命令清单及显示结果 1．交换机（路由器）A 夏战辉： ra(config)#hostname RA RA(config)#int s1/2 RA(config-if)#ip add 172.16.10.1 255.255.255.0 RA(config-if)#clock rate 64000 RA(config-if)#clock rate setting is only valid for DCE ports. no shutdown RA(config-if)#no shutdown RA(config-if)#exit RA(config)#int f1/0 RA(config-if)#ip add 192.168.10.1 255.255.255.0 RA(config-if)#end RA# Configured from console by console RA#show int s 1/2 serial 1/2 is UP , line protocol is UP Hardware is PQ2 SCC HDLC CONTROLLER serial Interface address is: 172.16.10.1/24 MTU 1500 bytes, BW 2000 Kbit Encapsulation protocol is HDLC, loopback not set Keepalive interval is 10 sec , set Carrier delay is 2 sec RXload is 1 ,Txload is 1 Queueing strategy: WFQ 5 minutes input rate 17 bits/sec, 0 packets/sec 5 minutes output rate 17 bits/sec, 0 packets/sec 450 packets input, 9900 bytes, 0 no buffer Received 450 broadcasts, 0 runts, 0 giants 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 abort 450 packets output, 9900 bytes, 0 underruns 0 output errors, 0 collisions, 4 interface resets 1 carrier transitions V35 DTE cable DCD=up DSR=up DTR=up RTS=up CTS=up RA#show runn Building configuration... Current configuration : 619 bytes ! version 8.4 (building 15) hostname RA ! ! ! ! ! ! ! ! ! no service password-encryption ! ! ! ! ! ! interface serial 1/2 ip address 172.16.10.1 255.255.255.0 ! --More- Show running-config 2. 交换机（路由器）B Show running-config 张碧波： ra(config)#hostname RA RA(config)#int s1/2 RA(config-if)#ip add 172.16.10.1 255.255.255.0 RA(config-if)#clock rate 64000 RA(config-if)#clock rate setting is only valid for DCE ports. no shutdown RA(config-if)#no shutdown RA(config-if)#exit RA(config)#int f1/0 RA(config-if)#ip add 192.168.10.1 255.255.255.0 RA(config-if)#end RA# Configured from console by console R