《2553ex-series-macho-pop》.pdfVIP

Part No. 69915EX Revised: December 2008 EXPORT MACHO POP Instruction Manual Models 2553EX 2554EX Cincinnati, OH 45241-4807 USA SAFETY PRECAUTIONS MACHO POP INSTALLATION INSTRUCTIONS Inspection of Shipment: Unpack all cartons and check thoroughly for any damage that may have occurred during transit. Damage claims should be filed immediately with the transportation company. Gold Medal is not responsible for damage that occurs in transit. Setup: Your new Macho Pop Popcorn Machine is completely assembled and tested at the factory. Remove all packing material and tape before starting operation. Electrical Requirements: The following power supply must be provided: 230 VAC, 50 Hz., 20 Amp Fused Circuit The 2554EX has a current draw of 7.4 Amps at 1700 Watts. The 2553EX has a current draw of 10 Amps at 2300 Watts. Your electrician must furnish sufficient current for proper machine operation. We recommend this popper be on a dedicated and circuit protected line. Failure to wire properly will void the warranty and can result in damage to the heat elements, light, motor and etc. It is Gold Medal Products Company’s recommendation that this machine be plugged directly into a wall outlet. The use of extension cords is not recommended due to safety reasons and the popper’s performance will be sacrificed/reduced. Before Plugging in the Machine: 1. Make sure that the wall outlet can accept the three (3) prong grounded plug on the power supply cord. 2. The wall outlet must have the proper polarity. If in doubt, have a competent electrician inspect the outlet and