《AS_1554.2-2016_Stud_Welding》.pdf

AS/NZS 1554.2:2003 (Incorporating Amendment No. 1) Australian/New Zealand Standard™ Structural steel welding Part 2: Stud welding (steel studs to steel) AS/NZS 1554.2:2003 This Joint Australian/New Zealand Standard was prepared by Joint Technical Committee WD-003, Welding of Structures. It was approved on behalf of the Council of Standards Australia on 3 June 2003 and on behalf of the Council of Standards New Zealand on 4 June 2003. It was published on 5 August 2003. The following are represented on Committee WD-003: Australian Chamber of Commerce and Industry Australian Industry Group AUSTROADS Bureau of Steel Manufacturers of Australia Electricity Supply Association of Australia Institution of Engineers Australia New Zealand Heavy Engineering Research Association New Zealand Non-destructive Testing Association New Zealand Welding School Steel Reinforcement Institute of Australia University of Sydney Welding Technology Institute of Australia Keeping Standards up-to-date Standards are living documents which reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Between editions, amendments may be issued. Standards may also be withdrawn. It is important that readers assure themselves they are using a current Standard, which should include any amendments which may have been published since the Standard was purchased. Detailed information about joint Australian/New Zealand Standards can be found by visiting the Standards Australia web site at .au or Standards New Zealand web site at www.standard