WorkoverRigOperationandSafety修井机.ppt

Operating Instructions for XJ250P Workover Rig 修井洗井车操作规程及注意事项 1 Check list before start the engine and drive the rig 行车时发动机起动前的准备 1-1Check the radiator, fuel tank and oil case 检查水箱、燃油箱、润滑机油的水油是否清洁充足。 1-2Check the steering and brake system检查转向、制动机构是否灵活可靠。 1-3Check the accumulators and other electrical components 检查电瓶是否充足，电器系统元件是否工作正常。 1-4 Check the oil of transmission and transfer case检查变矩器液力传动油及分动箱润滑油是否充足清洁。 1-5 Put the transmission gear shift on neutral position检查变矩器档位是否在空档。 2 Start the engine 发动机起动： 2-1 According to the operating instructions of engine按发动机使用手册中有关规定执行。 2-2 If the engine can be started in 30 seconds, it will be restarted three minutes later.发动机在30秒内不能启动，应停3分钟后再启动。（控制系统有延时5分钟控制）。 2-3 If the temperature cannot reach 650C, the engine can not be loaded or accelerated. Check the instruments.起动后温度未达到650C，切勿加载或高速运转，并检查各仪表是否正常。 2-4 The engine should avoid running in low speed. The reasons are that charcoal accumulating in the firebox, speeding the damages of parts and the waste of fuel.应减少低速运转，如下原因：造成燃烧室积炭；加大发动机零部件早期损坏；浪费燃料。 3 Engine shut off 发动机的停机 3-1 Before been shut off, the engine should run at low speed at least five minutes. This action can cool down the engine and let the supercharger has enough lubricating oil. 发动机工作完成后应低速运转5分钟，使发动机发热部件冷却，蜗轮增压器有足够的润滑油。 4 Check list before driving the rig 动载车起步前检查： 4-1Check the fastness of deck, mast, walkway, handrail, traveling block, low wellhead operating deck, tools, guylines.检查工作台面、井架、走道、护栅、游车大钩、低井口平台、工具、绷绳等是否固定。 4-2 Check the tire air pressure.检查轮胎气压是否充足。 4-3 Make sure that the transfer case is on the drive position.检查分动箱接合器是否在行车位置。 5 Cautions while drive. 行车注意事项： 5-1 Strictly forbids shifting into low gear for slowdown while driving in high speed. 严格禁止在高档高速行驶时用低速档减速。 5-2 Strictly forbids shifting from forward into backward, it will damage the transmission seriously.严