第15章 HDLC和PPP【第六天】詳解.pptVIP

查看 HDLC 和 PPP 的封装 Router#show interface s0 Serial0 is up, line protocol is up Hardware is HD64570 Internet address is 10.140.1.2/24 MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255 Encapsulation PPP, loopback not set, keepalive set (10 sec) LCP Open Open: IPCP, CDPCP Last input 00:00:05, output 00:00:05, output hang never Last clearing of show interface counters never Queueing strategy: fifo Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 38021 packets input, 5656110 bytes, 0 no buffer Received 23488 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 38097 packets output, 2135697 bytes, 0 underruns 0 output errors, 0 collisions, 6045 interface resets 0 output buffer failures, 0 output buffers swapped out 482 carrier transitions DCD=up DSR=up DTR=up RTS=up CTS=up  完成本章的学习后，你应该能够掌握： 在广域网的串行口上配置PPP 协议 在一个 PPP 连接内配置PAP和CHAP验证 查看点到点的 PPP 协议配置情况 本章总结 1. 在Cisco路由器上有哪三中广域网连接类型? 2. PPP有哪两种封装协议，它们有哪些优缺点? 问题回顾 Purpose: This chapter provides a brief overview WAN connections. It also discusses the HDLC and PPP protocols. Timing: This chapter takes approximately 1.5 hours to present. Note: This section has an optional laboratory exercise in which students configure PPP on a point to point serial connection. This exercise is optional because students will again configure PPP over an ISDN-BRI connection. Contents: Objectives—This section explains what the student will be able to do at the end of this chapter. WAN Overview—This section describes when to use WAN connections and different types of WAN connection options. Configuring HDLC Encapsulation—This section describes when to use HDLC and how to enable it on a serial point-to-point connection. PPP Encapsulation Overview—This section describes how PPP and PPP authentication works. Confi