承包商安全管理和工厂的作业许可制度祥解.ppt

* APPLICABLE OSHA STANDARD 1926.550(a)(13) Where necessary for rigging or service requirements, a ladder, or steps, shall be provided to give access to a cab roof. (ii) Guardrails, handholds, and steps shall be provided on cranes for easy access to the car and cab, conforming to American National Standards Institute B30.5. (iii) Platforms and walkways shall have anti-skid surfaces. * APPLICABLE OSHA STANDARDS 1926.550(a)(13)(ii) Guardrails, handholds, and steps shall be provided on cranes for easy access to the car and cab, conforming to American National Standards Institute B30.5. 1926.550(a)(13)(iii) Platforms and walkways shall have anti-skid surfaces. * Keep the load as close as possible to the ground when picking and carrying a load. 1926.550(a)(19) All employees shall be kept clear of loads about to be lifted and of suspended loads. * APPLICABLE OSHA STANDARD 1926.550(g)(3)(ii)(A) Cranes and derricks with variable angle booms shall be equipped with a boom angle indicator, readily visible to the operator. The boom angle indicator is an accessory device that measures the angle of the boom base section centerline to horizontal. * Level the crane according to the manufacturer’s specifications. Extend outrigger beams. 1926.550(g)(3)(i)(D) The crane shall be uniformly level within one percent of level grade and located on firm footing. Cranes equipped with outriggers shall have them all fully deployed following manufacturers specifications, insofar as applicable, when hoisting employees. Be mindful of asphalt which easily becomes a shifting, soft surface under a concentrated load. * Reference 1926.550(a)(1) Attachments used with cranes shall not exceed the capacity, rating, or scope recommended by the manufacturer. Reference:ANSI B30.5-1968 5-1.7.4 Sheaves Sheave grooves shall be smooth and free from surface defects which could cause rope damage. the cross sectional radius at the bottom of the groove should be such as t