多室式钢管混凝土形构件纯弯力学性能研究.pdfVIP

29 卷 9 期 Vol.29 No.9 工 程 力 学 2012 年 9 月 Sep. 2012 ENGINEERING MECHANICS 185 文章编号：1000-4750(2012)09-0185-08 多室式钢管混凝土 形构件纯弯力学性能研究 屠永清，严敏杰，刘林林 (北京航空航天大学土木工程系，北京 100191) 摘 要：进行了4 个多室式钢管混凝土T 形试件和2 个多室式空钢管T 形对比试件的纯弯试验，着重研究前者在 纯弯状态下的变形过程及破坏形态，同时考察了截面尺寸、加载位置等参数对其纯弯力学性能的影响。试验结果 表明：增大截面腹板高度能显著提高多室式钢管混凝土T 形试件的抗弯承载力；力分别作用在翼缘或腹板时其承 载能力有一定的差异；试件的破坏形态以整体弯曲为主。采用有限元方法对多室式钢管混凝土 T 形试件的弯矩- 挠度曲线进行了全过程分析，与试验结果吻合较好。最后在参数分析的基础上提出了多室式钢管混凝土T 形构 抗弯承载力的实用计算方法。 关键词：钢管混凝土；多室式；T 形截面；纯弯；有限元；承载力 中图分类号：TU398.9 文献标志码：A doi: 10.6052/j.issn.1000-4750.2010.12.0899 STUDY ON MECHANICAL PROPERTIES OF MULTI-CELL T-SHAPED CONCRETE FILLED STEEL TUBES SUBJECTED TO PURE BENDING TU Yong-qing , YAN Min-jie , LIU Lin-lin (Department of Civil Engineering, Beijing University of Aeronautics and Astronautics, Beijing 100 191, China) Abstract: 4 multi-cell T-shaped concrete-filled steel tubes (MT-CFST) and 2 multi-cell T-shaped steel tubes (MT-ST) subjected to pure bending were tested. The failure modes and the effects of cross-section dimensions and loading position on pure bending behaviors of MT-CFST specimens were examined as well. It was found in the experiment that the flexural capacities of MT-CFST specimens can be significantly enhanced by increasing the web height. The loading capacity was different when the force acted on the flange or the Web. Failure modes were mainly overall bending. Subsequently the finite element method is used to calculate the moment-deflection relationships of the MT-CFST specimens. The calculated curves show good agreement with the presented test results. Based on the parametric analysis, a simplified formula for calculating the ultimate strength of the new type of composite