大齿轮轮芯堆焊机动力头设计.docVIP

目 录 1 绪论 1 2 堆焊简介 4 3 总体方案设计 8 3.1 动力头的总体设计要求 8 3.2 动力头的设计 8 4 蜗轮蜗杆的传动设计 11 4.1 高速级传动设计 11 4.2 低速级传动设计 16 5 轴的校核与设计 21 5.1 轴的设计 21 5.2 输入轴 21 5.3 输出轴 23 5.4 中间轴的校核 25 6 滚动轴承的选择及校核计算 32 6.1 输入轴上的轴承 32 6.2 输出轴上的轴承 33 7 键连接的选择及校核计算 37 8 联轴器和箱体的设计计算 39 8.1 联轴器 39 8.2.箱体 41 9 减速器结构与润滑、密封方式的概要说明 43 10 结论 45 参考文献 46 致谢 47 Wheel center welding machine power head design Abstract ：From outside the ring gear, wheel core and key combination engagement ring is part of it using high quality steel, round core for the casting gear shaft with key connectionutside the ring and the wheel core by interference fit, with the temperature difference method assembly. Wheel core and outer ring is no relative movement, no wear. When replacement or repair outside the ring gear shaft parts, etc., you need to gear collapse, this time from the outer ring round the outer surface of the core was forcibly pulled out, with the surface will be destroyed, gear wheel core is also easy by wear and tear. In order not to affect the working condition of gears, wheel outer surface of the core needs welding and machining to restore wheel core and the outer surface finish. Within the same round hole injury also used as a core method of welding repair. This power head welding machine is designed to be used for this process This designs the gear of wheel center welding machine, the focus is the design of transmission and shaft. The primary purpose of the work is to meet basic performance, second is on this basis to reduce the size and weight of the gear as much as possible to compact structure and to manufacture esaily. The gear structure of dynamic head has many types, the first to meet the performance of this design is ratio and intensity, the second is considered from the equipment convenient, smaller size, lower cost and so on. After the design the gear should be easy to produce, structure simple, practical, easy installation and low cost. Keywords: wheel center, welding machin