路由基础第九章介绍.ppt

Slide 1 of 2 Purpose: Emphasize: The 1900 supports DISL. Note: At the time of the beta, the core switch (2900xl) does not support DISL. If trunking is on at one end, and off at the other end, the link will be down. Layer 2 of 2 Note: The Catalyst 1900,at the time of the beta, only supports ISL trunking. It does not support 802.1Q trunking. Layer 2 of 2 Layer 2 of 2 Note: Type: Default is Ethernet (other types are FDDI and Token Ring). SAID: Is used for FDDI trunking. MTU: Default is 1500 for Ethernet VLAN. STP: The 1900 only supports 802.1d Spanning-Tree Protocol. It does not support DEC or IBM Spanning-Tree Protocol. Routers support all three Spanning-Tree Protocol standards. Other parameters: Used for Token Ring or FDDI VLANs. Note: The output shows that there are currently no ports assigned to VLAN9. Layer 2 of 2 Note: In the lab, we will only be configuring static VLAN membership. Layer 2 of 2 Emphasize: Port 1 = e0/1, ……. AUI = e0/25, A = fa 0/26, B = fa 0/27 Layer 2 of 2 Emphasize: Port 1 = e0/1, ……. AUI = e0/25, A = fa 0/26, B = fa 0/27 Layer 2 of 2 Note: To adjust the spanning tree timers or bridge priority on the 1900, use the following global configuration command: wg_sw_a(config)#spantree-template 1 ? forwarding-time Set a Spanning Tree FORWARD Interval hello-time Set a Spanning Tree HELLO Interval max-age Set a Spanning Tree MAX AGE Interval priority Set a Spanning Tree PRIORITY vlan Assign up to ten VLANs to a bridge template On the 1900, you can assign up to four spanning tree templates, then you can assign VLANs to each template. When you modify a template, you are modifying all the VLANs belonging to that template. Purpose: This slide discuss the initial configurations on the routers and switches. Note: There is no setup mode on the Catalyst 1900 switch. Slide 1 of 1 Purpose: Emphasize: wg_sw_2950#show vtp status wg_sw_2950#show vtp status VTP Version : 2 --