模型机检验标准.docVIP

PAGE  目 的(Aim:) 为保证机模质量，给检查作业提供依据，为客户提供合格的产品，特制定本标准。 In order to insure the quality、give the rules to the inspection action and supply our customers with super products, we establish the standards. 范 围(Range) 适用于LG公司模型机检验 All the LG dummies are valid 检验流程：（Inspection process） 模型机整机检验 Whole dummy inspection 模型机底面壳、翻盖检验 Body rear、folder inspection 模型机转轴、推盖检验 Hinge、Sliding inspection 模型机镜片检验 Lens inspection 模型机屏幕检验 LCD image inspection 模型机按键检验 Keypads inspection 模型机电镀键检验 Electroplating parts inspection 模型机重铁检验 Metal pads inspection 模型机配件检验 Accessories inspection 模型机包装检验 Package inspection 注：①以上工序的检验参照相应的检验标准； All the inspection process should be comply with the relative standard. ②在检验过程中如某一检验标准不适用可省略其检验步骤。 Any standard is inapplicable, omitting the inspection process 1．模型机整机检验标准 Whole dummy inspection standard 1.1、检验标准： Inspection standard: 1.1.1 长、高、宽与样机相差小于1mm； Comparing the length、height、width with the real phone, △E1mm; 1.1.2 重量与样机相差±5g； Comparing the weight with the real phone, △E=5g 1.1.3 颜色与样机基本一致；(在客户确认样板与真机颜色之间可接受) Color should keep consistent with the real phone (Between the GS and the real phone is acceptable) 1.1.4 手感质感与样机基本一致；(在客户确认样板与真机效果之间可接受) Touching feeling should keep consistent with the real phone (Between the GS and the real phone is acceptable) 1.1.5 整机形状、外观及配件的形状、外观与样板机基本一致。（在客户确认样板与真机效果之间可接受） Both the shape、appearance of the whole and the accessories should keep consistent with the real phone(Between the GS and the real phone is acceptable) 1.2、检验方法：(Inspection measure) 1.2.1 用QC专用带表卡尺（0～150mm）进行测量 Measuring with the QC callipers. (0~150mm) 1.2.2 用QC专用（0～1000g）电子秤进行测量。 Measuring with the QC electronic steelyard.(0~1000g) 在2只40W的日光灯下，光源距离被侧面30～50cm灯光下，平视距离20～30cm，上下倾斜150，用QC专用点、线标准菲林比较。 With 2pcs of 40W lamp, being 30~50cm from the lamp, 20-30cm from eyes, and leaning 150 in upper and down, Comparing with the QC standard film. 2．模型机底面壳，翻盖检验 (只适用带翻盖的模型机) Dummy body