提升机构-摩檫提升机钢丝绳张力检测系统设计-说明书.docVIP

摘 要 提升是煤炭行业里的重中之重。目前煤矿上大多采用多绳摩擦式提升机。是依靠钢丝绳与摩擦轮衬垫之间的摩擦力来提升。由于众多因素的影响，在使用一段时间后,会使各钢丝绳之间受力不均、张力不平衡，这将会造成钢丝绳的疲劳破坏和摩擦衬垫的早期报废，甚至会造成滑绳、断绳等重大事故。因此，在线检测各钢丝绳张力的情况一致，保持钢丝绳受力一致对延长钢丝绳的寿命、减轻衬垫磨损、保证设备安全运行有着很重要的意义。本文在参考分析其他资料的基础上，设计了摩擦提升机钢丝绳张力监测系统，该测试系统分为机械装置和信号测试两部分。机械装置是由支架 压轮 底座 轴 轴承等主要部件组成。并根据实际工作情况等因素，合理选择加工材料，确定支架和底座的外部尺寸，并对轴及轴承等进行强度校核和寿命计算。以来完成用直接接触法测量各钢丝绳的张力。测试部分依次由弹性元件 放大装置 滤波装置 信号转换装置 处理装置 显示装置组成。从而使所测得的张力一步步由力信号通过弹性元件转换成电信号再通过信号放大 滤波 采集进而显示出钢丝绳的张力的大小。该测试系统将用于实践，会对安全生产起到积极的作用。 关键词多绳摩擦提升机钢丝绳张力传感器 Abstract Enhance the coal industry a top priority. Most of the current use of coal on the multi-rope friction hoist. Relying on wire rope and the friction between the friction wheel liner to improve. Because many factors in the use of a period of time, bring the rope were among the Shouli Bu, tension imbalance, which will result in fatigue failure of wire rope and the friction lining of early retirement, or even cause slippery rope, broken rope and other major incidents. Therefore, online detection of the rope tension in line, keeping the same wire by the force of the rope to extend life, reduce pad wear, to ensure the safe operation of equipment has very important significance. Analysis of other information in the reference paper based on the design of friction hoist rope tension monitoring system, the test system is divided into mechanical devices and signal test two parts. Mechanical device is the base from the support roller shaft bearings and other major components. Work based on factors such as actual and reasonable material selection process, make sure the support and the base of the external dimensions, and the shaft and bearing, etc. check the strength and life prediction. Since the completion of direct contact with the wire rope tension measurement. Test parts of this device by the elastic element to enlarge the signal conversion device Filter display device component processing device. So that the tension measured step by step from the force signals into electrical