SPT2.0试验规程.doc

NCHRP Project 9-29 Simple Performance Tester for Superpave Mix Design 路面设计基本性能试验系统 Equipment Specification For The Simple Performance Test System 基本性能试验系统规格书 LIMITED USE DOCUMENT文本使用限制 The information contained in this Document is regarded as fully privileged. Dissemination of information included herein must be approved by the NCHRP.本文档所包含的任何信息是完整专利。任何信息散布须经NCHRP认可。 March 26, 2004 Advanced Asphalt Technologies, LLC 108 Powers Court, Suite 100 Sterling, Virginia 20166 Table of Contents目录 Table of Content目录 1 1.0 Summary 概述 2 2.0 Definitions定义 7 3.0 Test Specimens试验试件 8 4.0 Simple Performance Test System SPT系统 9 5.0 Compression Loading Machine加载机 10 6.0 Loading Platens加载盘 11 7.0 Load Measuring System荷载测量系统 12 8.0 Deflection Measuring System形变测量系统 12 9.0 Specimen Deformation Measuring System试件形变测量系统 13 10.0 Confining Pressure System围压系统 14 11.0 Environmental Chamber环境舱 16 12.0 Computer Control and Data Acquisition计算机控制和采集系统 17 13.0 Computations计算 30 14.0 Calibration and Verification of Dynamic Performance动态性能的标定和验证 40 15.0 Verification of Normal Operation常规操作验证 41 16.0 Documentation文件 41 17.0 Warranty质保 42 Annex A. Simple Performance Test System Flow Time Test SPT流变时间试验 43 Annex B. Simple Performance Test System Flow Number Test SPT流变次数试验 50 Annex C. Simple Performance Test System Dynamic Modulus Test SPT动态模量试验 57 Annex D. Procedure for Developing a Dynamic Modulus Master Curve for Pavement Structural Design Using The Simple Performance Test System使用SPT试验系统生成用于路面结构设计的动态模量主曲线的过程. 65 Annex E. Specification Compliance Test Methods for the Simple Performance Test System SPT系统一致性试验方法规范 78 Annex F. Minimum Testing Program For Comparison of a Non-Standard Specimen Deformation Measuring System to the Standard Specimen Deformation Measuring System非标准和标准试件形变测量系统比较的最小测试程序 86 Summary概述 This specification describes the requirements for a testing system to conduct the following National Cooperative Highway Research Progr