研究利于紧线应力与正确度的设计要求(精选).docVIP

研究利于紧线应力与正确度的设计要求 一般条件下,张力放线段的长度应包括15个放线滑车的线路长度,宜为5～8km。当选择牵张场地非常困难时,放线段内包括的放线滑轮数量不应超过20个；2、跨越特别重要的跨越物（如铁路、高速公路、110kV及以上电力线等）宜适当缩短放线段长度,以确保安全和快带完成跨越架线任务；3、选用的张力场、牵引场应是地势平坦、交通方便的直线塔之间;放线段的起止塔宜选用上扬杆塔；4、应尽量按导线盘的导线长度的倍数选择放线流程段,以减少直线压接管数量；5、在以放线段作为紧线段进行架线时,选用张力放线段代表档距与所在耐张段代表档距接近的方案,以利于紧线和提高紧线应力与设计要求应力的正确度；6、非特殊情况,尽量不以耐张塔作为张力放线段起止塔。 Under general conditions, the length of tension pay-off period should include 15 pay-off of a block, appropriate for 5 ~ 8 km. When choosing tension field is very difficult, pay-off segment includes pay-off pulley number should not be more than 20; 2, spanning across particularly important content (such as railway, highway, 110 kv and above power lines, etc.) should be appropriate to shorten the feeding length, to ensure the safety and fast take across lines of task; 3, choose the tension field, traction should be flat, convenient transportation of the straight line between tower; Rose pay-off period appropriate chooses the start-stop tower tower; 4, should as far as possible according to the lead wire length is a multiple of choose the feeding process of plate, in order to reduce the line pressure to take over the number; 5, in the feeding section as a tight line stringing, choose tension pay-off period on behalf of span and represent the resistance to a section where span nearly solutions, so tight line and improve the tight line of stress and stress the accuracy of the design requirements; 6, the special circumstances, try not to tension as tension pay-off period of start-stop towers. 　　1、牵张场地应满足牵引机、张力机能直接运达到位,且道路修补量不大;桥梁载重能满足承载力不小于25t的要求。2、地形应平坦,能满足布置牵张设备、布置导线、施工操作等要求。场地面积不应小于张力场55m×25m,牵引场30m×25m。3、如果需要直线转角塔（ZBJ塔）作过轮临锚时,档内有重要交叉跨越或档内不允许导线接头时,牵、张机出口与邻塔导线悬挂点高差角大于15°时都不宜选作牵、张场。 1, the tension field should be meet the tractors, shipped directly to a function of tension, and road repair quantity is not big; Bridge load can satisfy the requirement of bearing capacity of not less than 25 t. 2, terrain should be flat, can satisf