planerEN 50144-2-14.docVIP

电刨特殊要求 EN 50144-2-14:2001 条款 内容 判定 2.2.18 正常负载: 电刨连续工作时的负载, 输入功率为额定输入功率 7.1 铭牌上: 额定空载转速 the rated no-load speed in revolutions per min. 刀头的旋转方向 a clear indication of the direction of rotation of the cutting head by means of an arrow, raised or sunk, or by any other means no less visible and indelible 7.13.1 说明书上应增加: 配置合适的刀片和正确的调节方法 instructions for the fitting of the blades and their adjustment to the correct position 使用的刀头的型号 type of cutting heads which can be used 正确使用吸尘装置的信息 information on the correct use of the dust collection equipment 7.13.2 说明书上应增加: 仅使用尖的刀片 only use sharp blades 工具停转后,再放好 wait for complete run-down before putting the tool aside 10.1 不必比较Pr Pn 18 机械防护Mechanical hazards 18.101 Cutting heads shall have a circular section along the whole cutting width except for the blades, the fixing screws and full chip clearance area 18.102 当刀片与固定桥座平行时,刀片不能大于鼓半径1.1mm 图102中a the blades when aligned with the fixed shoe shall not project by more than 1.1mm radially beyond the drum as per dimension “a” in Fig. 102 18.103 最大的夹隙距离 图102 S the max. chip clearance distance , see fig.102 S d 80mm: Smax 0.235d+7.2 d 80mm: Smax 0.1d+18 18.104 切割边的旋转周与可调节鞋的端面板间的距离不能大于5mm b 5mm, fig. 102 the distance “b” between the rotating circle of the cutting edges and the lips of the adjustable shoe shall not exceed 5 mm, from zero planning depth to the max. adjustable planning depth. 18.105 刀片应在鼓中,不能依靠摩擦避免刀片飞出去 以螺钉或螺栓固定刀片 The blades shall be secured in the drum in such a way that fiction alone is not relied upon to prevent the ejection of the blades 夹紧螺钉或螺栓至少有五个螺纹 when clamping screws or blots are fixed directly into a steel drum they shall engage for a min. of five full threads. 18.106 鼓中安全刀片系统的结构应适于调节和更换刀片而不影响安全 the system for securing blades in the drum shall be so designed and made that replacement and adjustment of the blades does not compromise safety 18.107 夹紧螺钉或固定刀片的元件硬度至少HRC20 800N/mm2 the clamping screws or the blade fixing elemen