WEM系统结构.pptVIP

Structure of WEM systemWEM系统结构 ??? Hardware 硬件??? Card Cages ,Main board, Hard disk, I/O board, Serial board, Lan board,Terminal, etc. 板卡柜, 主板, 硬盘, I/O (进线/出线)板, 系列板, 网卡板, 终端板等 ??? Software 软件??? FMB-3000, Blending System ,ARC, Hard disk setup , etc. FMB-3000, 混合系统, ARC, 硬盘安装程序等 Step’s WEM processWEM工作过程解析 Automatic Mode自动型 Manual Mode手动型 Method of WEM receive signal from Weigh IndicatorWEM从重量显示器上接受信号的方法 Trouble shoot ? Weight loss故障表? 重量损失 Check Ribbon cable because : When some wire are broken, it make sum of value bit loss. 　检查带状电缆，因为有的电线破断会造成比特数值（二进制）之和减少 Example: Actual weight = 2680.5 KG. If bit # 14,15 lost Signal , make value weight = 2080.5 KG. It differentiate about 600 KG. 例如: 实际重量＝2680.5 KG 如果损失比特信号1415, 使得　显示重量＝2080.5 KG 其差值约为600 KG. STD Bus Card Cages标准接插板卡柜 Trouble from Card cages板卡柜存在的故障 If the power supply is not functional : - CPU cannot process functionally. - Watch Dog timer cannot process functionally. - Signal loss between I/O board and SSR board. 如电源不正常: - CPU不能正常工作. - 数据输出计时器不能正常工作. - I/O 板与SSR 板之间的信号损失 Slot on Card cages are broken. (Wiring ripped.) Slot on Card cages dirty. (Function board cannot connect with circuit. 板卡柜中的插槽破裂（线蚀） Slot on Card cages dirty. (Function board cannot connect with circuit. 　板卡柜中的插槽脏污（功能板不能与线路连接） CPU BoardCPU 板 Trouble from CPU boardCPU板存在的故障 If battery are empty or low Volt. (battery time 5-7 years): - When we power off and power on again May be found that cannot boot from hard disk or ram board. - Time and Date are reset. If CPU board decline the process will mistake. 如果电池用完或电压太低.(电池寿命5-7年): - 当切断电源再接通时,可能发现不能激活硬盘或缓冲板. - 时间与日期需要重新调整. Serial Board (Old Model)系列板 (旧式) Serial Board (New Model)系列板(新式) Trouble from Serial board 系列板存在的故障 Cannot connect with WEM system if problem on 1-J1 Cannot Print if problem on 1-J3 Cannot communicate by CPU-CPU or remote terminal if problem on 1-J2 or 1-J4 Often times when 1-J1 are failure, the 1-J3 are