Flash制作动广告图片效果.docVIP

接下来我们就开始做这个效果吧。1。首先新建一个flash文档，导入5张图片（我们这里做5张图片连续滚动效果，当然你要做更多，就随意了。。。） 2。接下来我们新建一个图形元件，把图片依次摆成如图样子。 在摆放的时候可以通过属性控制图片的大小： 3。接下来就是排列图片了，排成如下的样子： 排的时候可以用对齐面板： 4.把所有图片复制，粘贴放成如图的样子：（这样是为了让图形播放起来连贯） 5。然后再新建一个按钮，在指针经过处插入关键针， 6.然后画一个矩形，白色填充，大小和你的图片设置大小一样，调整透明度，如图： 7。新建一个mc1，把图形1拖进去，然后把按钮依次放在图形上，注意位置，这里可以用属性面板控制： 8。接下来在每一个按钮上添加as代码：on rollOver _root.mc.stop ; on rollOut _root.mc.play ;  其中mc是以后要民命的实例名。 9。新建一个mc2，我们把mc1拖进去，在100针出插入关键针，然后将图形向左拖，使得左端开头的位置变为右端结尾位置重合。 这里可以用属性窗口控制，我原来的x坐标为-250，我图片宽度为-750，所以新图片的位置就是-250-500 -750.‘ 10。做动作的补针动画，如图： 11.回到主场景，把mc2放进去，（命名为mc）。 好了现在就测试一下吧。由于考虑到新手，因此写的非常详细，包括一些技巧，所以显得有些罗索 of support and hanger. Cable hole plugging gaps should use qualified fireproof materials, block surface should have sufficient strength, surface appearance. When cables pass through the firewall, of lax structure of local fire safety clamps. Thermoplastics production, to comply with the process, no bubbles in the thermoplastics pipes, linear nose consistent with the core wire specifications, contact is good, no cracks, break. Tinned copper nose clean solder full exterior surface is smooth without burrs. Control cable Assembly should be fastened, dense, solid, clean, and beautiful. Secondary wiring the cable terminations should be arranged by the actual location of the device line cards, the wiring from the upper to the lower, from left to right in the order. Fixed to maintain consistent spacing between lines, flat, should be around the corner in the same location, same shape, to ensure that the wiring process neater and more elegant. 5 thermal process control measures for quality problems 5.1 control thermal duct system leakage measure to ensure that the use of electric door and actuator installation quality and equipment to the site to check its seal, acceptance, in order to fundamentally solve oil spill problems. Plant for local Panel after installation, in conjunction with the quality Department to check its overall quality, poor-quality parts rep