Specification and Design of a Video Phone System.pptVIP

Specification and Design of a Video Phone System by Wei Xiang Liang You Instructor Professor C.A. Papachristou April 2000 System Functions Block Diagram of H.324 Video Phone System Elements Video I/O equipment including cameras and monitors, their control and selection. Audio I/O equipment including microphone and loudspeaker, telephone instrument or equivalent. Human user system control, user interface and operation. The Video codec H.263 is for low bit rate communication. The Audio codec G.723 encodes the audio signal from the microphone and decode the audio signal output to speaker. The Control protocol H.245 for multimedia communication which provides capability exchange, signaling of commands and indications, and messages to open and fully describes the contents of logic channels. * * ECES 488 Embedded System If videophone rings and the user responds, the device works normally as a phone. If user does not respond, the answering machine is going to be activated and the input data audio and/or video will be routed to their respective units. If during conversation, user decides to send image out, a button can be pressed to ask the CCD camera to capture picture. The image will be processed and sent. If the device get an incoming image, it will be channeled to the respective units and the data will be processed, displayed and saved. ECES 488 Embedded System System Specification Power: supplied by external power supply Type of Communication: transmission and receipt of voice +simultaneous video Transmission Time: max. 30 fps frame per second Modem: using built-in modem Standards: system ITU-T H.324 Camera: digital CCD sensor Display: local view display-LCD Audio: frequency response 50Hz~3.4kHz Transmission line: regular telephone line ECES 488 Embedded System ECES 488 Embedded System ECES 488 Embedded System System Elements cont’d ECES 488 Embedded System The Multiplex protocol H.223 is for low bit rate multi