MyEclipe8.5安装以及TomCat配置.docVIP

MyEclipse8.5的安装及Tomcat配置 个人实践记录，希望能给初学J2EE的同学一些帮助 以MyEclipse8.5的安装以及Tomcat6.0的配置XP系统下的安装配置（win7基本一样） 首先安装jdk,在安装jdk时jre安装完成， 然后安装MyEclipse8.5，按装完毕，打开MyEclipse8.5，首次启动，选择路径 关闭close show center 然后配置环境变量（如果已经配置好的，那就直接运行） 环境变量的配置 我的电脑—高级—环境变量( 一、Adminstrator的用户变量新建： 1、变量名：Java_home 变量值为JDK所在的路径值（建议直接拷贝）例如我的： 2、系统变量：新建(变量名：classpath、变量值：. 3、 Path(编辑—更改变量值为jdk的bin 目录下（建议直接拷贝），注意：以英文分号结束 二、开始(运行(cmd—java(javac 以下，我着重介绍tomcat6.0配置的方法 启动MyEclipse8.5 File(new(web project 命名为LxxFirstWeb(finish(（打开工程）点击WebRoot—new JSP 默认为MyJsp.jsp—在body中输入“This is my first web page!”保存 一般情况下，我们会把apache-tomcat-6.0.14拷贝到C盘根目录下。打开C:\apache-tomcat-6.0.14\bin目录下，查找批处理文件：点击shutdown.bat，然后点击startup.bat。运行startup.bat时出现下图所示为成功！ 证明你的tomcat启动成功！ 现在关闭startup.bat然后运行shutdown.bat 在MyEclipse8.5中打开Window—preference 在type filter text中输入tomcat搜索 选择MyEclipseTomcat 选中Disable然后Apply 选择Tomcat 6.x 选择Enable 如图： 查看Launch选中Debug mode –Apply 现在选择OK！ 点击Tomcat 6.x –add Deployment (选择工程LxxFirstWeb(finish 运行项目 打开浏览器：输入网址： http://(IP地址)：（端口号）/（工程名）/（JSP文件名字.jsp） 连接：出现网页结果！成功！ 河南大学软件学院 Million. Water quality standards the dredging of river boundary section obtained provincial environmental protection Office special bonuses for wetland construction ... ... Million. But sober see, these achievements were made in the case of decreased rainfall for two consecutive years, we realize that environmental protection work still faced many problems in our County. Mainly in the PM2.5 and PM10 air quality monitoring indicators often exceeding, dredging of river sections water quality is not stable, and rural non-point source pollution has not been radical, Wade through the corporate environmental risk, livestock pollution rebound from severe, a wealth of protection and use of water resources is not well. If this years rainfall, these problems will be exposed, and raw materials caused a great deal of pressure to go green. To solve these problems, we focused on three aspects of the work of envi