模具专业英语12复习课程.pptVIP

* * 2.导套 4.导柱 10.扇形块 15.大头马车螺丝，步进螺栓 * 在对相对较厚的板料进行简单拉深时，料厚可能会足以防止起皱的发生。 其中一个控制压边圈的滑块在另一个滑块之前向着板料移动，并将板料定位。 * (9) A typical feed system for a four-impression, two plate-type mould is shown in Fig 9-1 and Fig 9-2. It is seen that the material passes through the sprue, main runner, branch runners and gate before entering the impression. （图9-1 和图9-2 是典型的两板式四腔模的浇注系统，熔融塑料通过主流道，分流道，浇口进入型腔） * UNIT 2 (10) As the temperature of molten plastic is lowered（降低） while going through the sprue and runner, the viscosity（粘度、黏性） will rise; however, the viscosity is lowered by shear heat generated when goi