集装箱正面吊发动机06259.pptVIP

二、电控发动机的简介 燃油油水分离滤清器 TWD1240VE (LHS VIEW) 发动机润滑系统图 TWD1240VE (TOP VIEW) 二、电控发动机的简介 以上介绍了电控发动机VOLVO1240VE, 而高压共轨电喷发动机除了燃油供油系与电控发动机的不同外，其余的基本一样，下面我们来看看高压共轨电喷发动机的燃油供给图： The cylinder liner is sealed against the coolant casing with rubber rings. No seal is usedat the top apart from a thin string of silicone.The lower seal consists of three rings fitted in grooves in the block. The two upper are made of EPDM rubber (black) while the bottom-most is made of flouride rubber (purple). A thin string of silicon rubber is applied between the liner collar and the block’s liner ringbefore the liner is fitted. The solid steel gasket is made in one piece to fit the entire engine. There are rubbersealing rings for water and oil ducts between the cylinder head and block.The liner’s contact surface with the steel gasket has a convex profile and it rises0.15 - 0.20 mm above the block surface. Just above normal idling, oil is sprayed from the piston cooling nozzles up under thepiston via a duct to the circular duct inside the piston ring carrier. This to cool thepiston crown and upper piston ring. The upper and the middle piston ring is market “TOP”. The lower ring (oil scraper ring)is reversible. The aftercooler lowers the boost temperature from max 240?C to 60?C and thepressure drop over the aftercooler is less than 3.5%. Cylinder head The cylinder head is of cast iron and manufactured in one piece which is necessaryin order to provide stable bearings for the overhead camshaft.The camshaft has seven bearing housings with removable bearing shells.Due to the four valve system with centrally located injector, the engine combustionchamber is fully symmetrical. The cylinder head is attached with 38 M16 bolts,equally distributed around each cylinder.Each cylinder has separate inlet and exhaust ports with cross-flow design.The valve guides and steel valve seats can be replaced.All valve guides have oil seals. The lower part of each injector is located in a coppersleeve wh