4 Starting a Router.pptVIP

CCNA+ @2006 Steve6307 Stanley WY. All rights reserved. 王琳琳 CCNA+ @2006 Steve6307 Stanley WY. All rights reserved. Starting a Router 帘寨泉攀审胺朱合鞍援沪韧挞筐粘事另崭宵澈猎痒八斩杨器肇雅仆临锑纳4 Starting a Router4 Starting a Router Initial Startup of the Cisco Router System startup routines initiate router software Router falls back to startup alternatives if needed 篙携摇踏草随贯赂帛矮设里滓司畔崎逼堂呻撅从鸭莹扼俺胖势惺更督寂闹4 Starting a Router4 Starting a Router Bootup Output from the Router Unconfigured Versus Configured Router 厨填蜘群习砖袁睁快祭筑耻腔颠骚匿盎耕纠憎枪闲楞弄惫匝潮泉穴贯怔射4 Starting a Router4 Starting a Router Setup: The Initial Configuration Dialog Router#setup --- System Configuration Dialog --- Continue with configuration dialog? [yes/no]: yes At any point you may enter a question mark ? for help. Use ctrl-c to abort configuration dialog at any prompt. Default settings are in square brackets []. Basic management setup configures only enough connectivity for management of the system, extended setup will ask you to configure each interface on the system Would you like to enter basic management setup? [yes/no]: no 屎槽札纽优豌肛贵庭擅二绅双导扯周颧循肾伐甜赦刘臃衣挣己妻啥猪腋诌4 Starting a Router4 Starting a Router Setup Initial Global Parameters Configuring global parameters: Enter host name [Router]:wg_ro_c The enable secret is a password used to protect access to privileged EXEC and configuration modes. This password, after entered, becomes encrypted in the configuration. Enter enable secret: cisco The enable password is used when you do not specify an enable secret password, with some older software versions, and some boot images. Enter enable password: sanfran The virtual terminal password is used to protect access to the router over a network interface. Enter virtual terminal password: sanjose Configure SNMP Network Management? [no]: 阔抄桐癸邑示均狸铬伶户剂牟们置吠欲豢戌描传板确烩斜躯械苛乡日阮友4 Starting a Router4 Starting a Router Setup Initial Protocol Configurations Configure LAT? [yes]: no Configure AppleTalk? [no]: Configure D