BTL5模拟量说明书.pdf

BTL5-A/C/E/G_ _-M/U_ _ _ _-P-S 32/KA_ _ Balluff GmbH Schurwaldstrasse 9 73765 Neuhausen a.d.F. Germany Phone +49 (0) 71 58/1 73-0 Fax +49 (0) 71 58/50 10 Servicehotline +49 (0) 71 58/1 73-3 70 E-Mail: balluff@balluff.de http://www.balluff.de Technical Description Users Guide english BTL5-A/C/E/G_ _-M/U_ _ _ _-P-S 32/KA_ _ Micropulse Linear Transducer in Profile Housing 2 english ducer system. In particular, steps must be taken to ensure that should the transducer system become defective no hazards to persons or property can result. This includes the installation of additional safety limit switches, emergency shutoff switches and maintaining the per- missible ambient conditions. 1.4 Scope This guide applies to the model BTL5-A/C/E/G...P... Micropulse transducer. An overview of the various models can be found in ? section 6 Ver- sions (indicated on part label) on page 7. Note: For special versions, which are indicated by an -SA_ _ _ des- ignation in the part number, other technical data may apply (affect- ing calibration, wiring, dimensions etc.). Read this manual before installing and operating the Micropulse Trans- ducer. 1.1 Proper application The BTL5 Micropulse transducer is intended to be installed in a ma- chine or system. Together with a controller (PLC) or a processor (BTA) it comprises a position mea- suring system and may only be used for this purpose. Unauthorized modifications and non-permitted usage will result in the loss of warranty and liability claims. 1.2 Qualified personnel This guide is intended for special- ized personnel who will perform the installation and setup of the system. 1.3 Use and inspection The relevant safety regulations must be followed when using the trans- 1 Safety AdvisoryContents 1 Safety Advisory 2 1.1 Proper application 2 1.2 Qualified personnel 2 1.3 Use and inspection 2 1.4 Scope 2 2 Function and Characteristics 3 2.1 Characteristics 3 2.2 Function 3 2.3 Available stroke lengths and magnets 3 3 Installation 3 3.1 T