壳体设计规范题库.pptxVIP

Introduction 介绍 Function Overview 功能概述 Gearbox Types 壳体类型 Design Guidelines 设计指南 Gears Shafts, Bearings, Fasteners, Flanges, Flange Sealing, Ribs, Joints, Radii, Wall thickness, Corrosion, Surface treatment, NVH 齿轮、轴，轴承、紧固件、凸缘、凸缘密封、筋、过渡连接，倒圆角，壁厚，腐蚀，表面处理、噪音 Materials Options 材料选择 Material Weight 材料重量 Suitable Casting Options 铸造类型 Sand Casting 砂型铸造 Gravity Die重力铸造;The aim of this guide is to help the designer to make an informed choice when designing a transmission case or casings. The choices taken will depend on many factors such as:本指南的目的是帮助设计人员在设计变速箱外壳时，作出正确的选择。需要考虑的因素如下：; Environment 环境 External Regime, package as well as recyclability of materials 外部政策，包装以及材料可回收性 Duty 工况 Life, Duty Cycle, Load regime, Torque and Power 路谱，负载，扭矩和动力 Weight重量 Target Vehicle weight, Transmission target weight – see materials 目标车辆的重量，变速箱的目标重量-由变速箱材料决定 Vehicle Type车辆类型 Transverse, Longitudinal, FWD, RWD, 2WD,4WD 横置，纵置，前轮驱动，后轮驱动，两轮驱动， 四轮驱动 ;; Provide an Oil reservoir for cooling and lubrication 为变速箱冷却和润滑提供油路系统 In addition mount or support other sub systems such as为其他子系统提供安装支撑，如下： Drive Clutches 驱动离合器 CSC Engine Starter Motors 发动机起动马达 Manual Shifter Systems 手动换档系统 Shift mechanisms, Rails Forks, Cable Brackets 换挡机构、手柄、拨叉、拉线支架 Hydraulic Shifter Systems 液压换挡系统 Automated Manual Shift Mechanisms 自动换挡系统 Wet Clutches – Powershift etc Pumps,Accumulators, Coolers, Filters etc 湿式离合器 - 动力换档原件，如泵，蓄能器，冷却器，过滤器等 Park Brakes 驻车制动 ; Depending on the type of Loads and installation casings can be divided into two types: 根据载荷的不同，可将壳体分为两类： Non Structural – the loads the casing sees are from the shafts and gears only with the casing ‘hanging ‘ off the engine and the vehicle side member 非结构性壳体--齿轮和轴作用到壳体上的作用力最后作用到发动机和车辆侧梁 pr