钣金产品检验规范.pdfVIP

文件编号：QA-002 版本version： 版次Edition Number :01 页码：第 页 ，共 12 页 文件名称 钣金产品通用检验规范 File Name 制订部门Develop Department: Sheet Metal Inspection Standards 品质部Quality Department 制订/日期 批准/日期 审核/日期Audit Prepare Approval Date Date Date 一.目的Purpose: 明确钣金件来料品质验收标准，规范检验动作，使检验、判定标准能达到一致性。 The explicitly sheet metal parts incoming quality acceptance standard, the standard inspection routine, In order to make inspection and judgement standard can achieve consistency. 二.范围 Appliction Range： 本标准规定了钣金部品的外观要求及性能测试、等项目。 本标准适用于供应商生产、研发摸底测试、试生产 、批量生产、IQC来料检验、QA增强性试验等各个阶段。 This standard specifies requirements for the appearance of the sheet metal part, performance testing, project, etc. This standard applies to supplier production, research and development baseline test, trial production and batch production, IQC incoming inspection and QA enhancement test all stages. 三.术语和定义： 下列术语和定义适用于本标准 The terms and definitions: the following terms and definitions apply to this standard 3.1 不良缺陷定义： Definition of defects： 3.1.1不需喷涂钣金件外观不良缺陷定义 Definition of appearance defects of sheet metal parts without spraying 3.1.2彩虹效应：镀锌有可能造成变色或“彩虹效益” Rainbow effect: There may be Rainbow Effect during the process of zinc plating. 3.1.3生锈/氧化：暴露在空气中的金属表面发生的化学反应。 Rustiness/oxidation: Metal surface exposed to air will react chemically. 3.1.4变色：底色或预期的颜色发生改变，或零件表面不同区域的颜色、光泽程度不一致。 Color-changing:Bottom color or prospective color changes; or the color and glossinee of different areas on the s