CCNA培训课程.docVIP

Training Course ：Cisco CCNA Interconnecting Cisco Networking Devices Part 1 focuses on providing the skills and knowledge necessary to implement and support a small switched and routed network. For the purpose of this course, a small network is defined as 1 to 20 hosts connected to a single switch, with the switch running a single VLAN (VLAN1). The switch is also connected to a router providing a routed link (Routing Information Protocol [RIP] and default) to a simulated Internet and corporate office. ICND1 works from the bottom up, providing knowledge and skills as they are needed. The course starts with an introduction to networks. It then introduces host-to-host communications using TCP / IP. Next, Layer 2 devices (switches) are introduced into the network. Next, Layer 3 devices (routers) are introduced into the network. The introduction of Layer 3 devices leads to the use of WANs and routing to connect the site to the Internet and corporate sites. Interconnecting Cisco Networking Devices Part 2 (ICND2) v1.1 is an instructor-led course that is presented by Cisco Learning Partners to their end-user customers. This five-day course focuses on using Cisco Catalyst switches and Cisco routers that are connected in LANs and WANs typically found at medium-sized network sites. Upon completing this training course, you should be able to configure, verify, and troubleshoot the various Cisco networking devices in a small network environment. Course Overview ： Course Introduction Module 1: Building a Simple Network Module 2: Ethernet LANs Module 3: WLANs Module 4: LAN Connections Module 5: WAN Connections Module6:Network Environment Management Capstone Lab: Network Environment Management Lab Guide Course Introduction Module 1: Small Network Implementation Module 2: Medium-Sized Switched Network Construction Module 3: Medium-Sized Routed Network Construction Module 4: Single-Area OSPF Implementation Module 5: EIGRP Implementation Module 6: Access Control Lists M