3.轴封系统, Gland Seal Steam System.pptx

波黑斯坦纳瑞1×300MW燃煤电厂 Stanari 1×300MW Coal Fired Power Plant, ;轴封系统 Gland Seal Steam System;轴封系统的工作原理 Gland Seal Steam System Work Principle 轴封供汽系统采用自密封式，并有防止汽轮机进水而损坏汽轮机的措施，轴封系统的供汽汽源满足机组冷、热态启动和停机的需要。该系统设有轴封压力自动调整装置、溢流泄压装置和轴封抽气装置等设备。 Gland seal steam supply system adopts self-seal, and has measures to prevent water entering into turbine and damaging turbine, steam supply source of Gland Seal Steam system meets requirements for unit cold/hot startup and stop. This system has Gland Seal Steam pressure automatic control equipments, overflow pressure relief equipments, gland steam extraction equipments, etc. ;在启动过程中，汽源供汽经压力控制站调压稳压后，一部分向经压力控制站调压稳压后，一部分向高、中压汽封供汽，另一部分经喷水降温向低压汽封供汽；当机组达到一定负荷后，低压轴封用汽完全由高、中压前、后汽封的漏汽供给，随着负荷继续升高，高中压汽封的多余漏汽自动溢流到排气装置，并由汽封溢流控制站自动保持供汽压力稳定。 During startup, after pressure control station controls and stabilizes the pressure of steam supply, one part of steam supply for high pressure/intermediate pressure steam seal, another part of steam supply for low pressure steam seal after water spraying and desuperheating; When unit reaches a certain load, the steam for low pressure Gland Seal Steam is completely supplied by the steam leakage of high pressure/intermediate pressure front/rear steam seal, as load keep rising, the surplus leaked steam of high pressure/intermediate pressure steam seal automatically overflows to exhaust steam device, and the Gland Seal Steam overflow control station automatically maintains steam supply pressure to be stable. ;设置在低压汽封供汽管路上的温度控制站自动调节以保持低压汽封供汽温度的稳定。总之，从启动前投汽封到停机后停止汽封送汽，该系统完全能自动调整，具有良好的负荷适应性。 The temperature control station at low pressure Gland Seal Steam steam supply pipeline automatically regulates, so as to maintain low pressure Gland Seal Steam steam supply temperature to be stable. In conclusion, from putting Gland Seal Steam into service prior to startup, till stopping gland seal steam supply after stoppage, this system can fully auto control, and can well adapt to loads.;轴封系统流程图 Gland Seal Steam System