掉败双眼皮修复剖析(国外英文资料).doc

失败双眼皮修复分析(国外英文资料) Remediation methods: (1) there is no cure for the heavy eyelid. Therefore, preoperative design such as the subject has no special requirement, the eyelid width is 7 ~ 8mm is good. In the operation, the lower margin of the incision should be sutured, not too high. Because the skin has the certain scale, so dissatisfied with double eyelid is too wide, can let the finger pull every day heavy eyelid line of upper eyelid skin, when this part of sagging skin, can cover a wide double eyelid, generally after 2 ~ 3 months of pull, double eyelid width can be narrowed. When necessary, redesign the low line and repair it with the trieyelid repair (see post). (2) for heavy eyelid too narrow cut method according to the double eyelid line incision are available, and the separation of upper eyelid skin, under the double eyelid line of gray line, and then take meibomian suture, optional at the site of the incision on the edge a little, so the result of the suture double eyelid will widen. If the subject upper eyelid skin flabby, remove the appropriate skin even, just can make double eyelid some wide, or flabby skin sagging upper eyelid will cover the heavy eyelid line makes heavy eyelid is too narrow. (3) in the case of asymmetries of the double eyelid, the method of incision is usually used to trim the weight of the heavy eyelid to the opposite side of the eyelid. If one side is too wide and the side is ok, then the method of drawing the skin is the way to pull the broadside eyelid to relax and the opposite side. Double eyelid line is shorter There are two cases of the shorter version The half double eyelid was formed by the loss of the upper eyelid in the canthus, which was due to a covering of the inner canthus. (2) the outer canthus of heavy eyelid line disappear, there are two reasons: one is the design line of orbital rims, 2 it is outside the stitches on line pressing lawmakers pressed tight enough, using embedded wire or cut lawmakers will bring deep tissu