特种设备习题(国外英文资料).docVIP

特种设备习题(国外英文资料) Individual choice At least two separate water tables shall be installed for boilers that are more than (B) t/h. P137 A. 0.1 B. 0.2 C. 0.5 D. 1.0 Pressure gauge on boiler pressure vessel, dial diameter should not be less than (C) mm. P137 150 A. 120 B. 100 C. D. 50 4. Inspection field (factory) in special motor vehicles to support the ground should be flat. Solid, should not have drainage. Shelter underground structures such as the above, the ramp slope is less than (C) % P173 3 A. 5 B. 10 C. 15 D. 5. When the temperature of the metal wall of pressure vessel shell and the component below (B) ℃, as defined by the minimum temperature should be the design temperature. P113 A. - 30 B. - 20 C. - 10 D. 0 Pressure vessels are commonly used for pressure gauges (A). P139 A. elastic element B. liquid column C. the piston D. power All the operating points of the crane above (C) m shall be protected. P161 1 A. B. 1.5 2 C. D. 2.5 When the elevator is in the car or the bottom of the squat, the device that absorbs the car and the heavy kinetic energy is called (D). A. safety gear B. speed limiter C. limit switch D. buffer It is not only possible to detect damage, but also to reveal the measurement of change and material characteristics. P153 A. Magnetic memory detection B. magnetic particle testing C. penetration testing D. eddy current testing 10. According to our country existing function division, included in the scope of safety supervision of quality and technical supervision department of the hoisting machinery including rated lifting weight is greater than or equal to 1 t. and hoisting height is greater than or equal to (B) m crane. P111 1 A. 2 B. 3 C. 4 D. The minimum distance between A crane and other equipment or fixed buildings should be maintained at (A) m. P160 A. 0.5 B. 1.0 C. 1.5 D. 2.0 The safety device of the boiler pressure vessel can be classified according to its performance or use, and the following (D) term is different from the other three. A. i