CASS生成断面操纵步调(国外英文资料).docVIP

CASS生成断面操作步骤(国外英文资料)(1) the line of line (must be a composite line) drawn on the diagram.(2) the order of the [new] under the command of the line.(3) hint: choose the vertical section line.(4) there is a window in which there is a window in which the middle pile points are obtained by selecting 1 [nodes], 2 [equal points], 3 [equal points and processing nodes].Input cross-section space: xx (meter), please give the space between adjacent sections.The length of the cross to the left: xx (meter)? Please give the length of the left side of the cross section.Enter the length of the right length: xx (meter)? Please give the length of the right side of the cross section.After clicking the button, you can see that there are several corresponding cross-section lines on the vertical section of the line drawn in (1).(5) the [generated] command [generated] under the command of the vertical section. Note: select the profile line, please select the vertical section line in (1).(6) in [file generated mileage] window, browse the positioning must open the [spot elevation data file name] (i.e., the coordinates of the original topographic map data files), and specify the need to save the file name] [generated mileage and the corresponding data file] [mileage files; And specify] [interpolation section line spacing (is sampling cross-sectional line spacing, rather than the pile spacing of the profile line), and cross-sectional] [start mileage.Through the above six steps, the mileage documents of multiple cross sections of the middle line of the road can be generated.Edit the road cross-section design document. ????? In [section method earthwork calculation] [road section] and [site section] command, a pop-up window need positioning mileage and cross-sectional design file, only mileage file without a cross-sectional design, is not an original terrain and the design of plane closed profile.The DEMO folder has a cross-sectional design file, zhd.txt, which is as follows:1, H = 89, I = 1:1,