Landsat TM 辐射定标和大气校订步调(国外英文资料).docVIP

Landsat TM 辐射定标和大气校正步骤(国外英文资料) Landsat TM radiation calibration and atmospheric calibration procedure One, data preparation Download the TM data from the USGS website or university of Maryland. USGS site to download the data is the raw data, in ENVI software File - Open External File - Landsat - Geotiff with meta just opened in the * * * * * * * * * * * _MTL TXT can Open all band data (except band6); Usgs site or at the university of Maryland website to download data may not have the original data, the ENVI software File - Open External File - Landsat - Geotiff with meta just opened in the * * * * * * * * * * *. Met can Open all band data (except band6) Two, radiation calibration There is a module for radiation calibration in ENVI 4.7. When the original TM image is opened, select Basic Tools -- Preprocessing -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- Step 2: select Landsat 4, 5, or 7 depending on the type of sensor. Take the time of Data Acquisition from the remote sensing image header file, and Sun elevation. If you Open it with the File - Open External File - Landsat - Geotiff with meta (Fast), sun elevation is already completed. Here the Calibration Type is chosen for Radiance. The output file, the calibration is complete. Third, atmospheric correction A simple atmospheric correction can be done with the FLAASH module of ENVI. Here are the steps for the FLAASH: 1. FLAASH module into method is Spectral - FLAASH, or the Basic Tools, Preprocessing, Calibration Utilities - FLAASH. The operating interface of the FLAASH module is divided into three parts: the top of the input output file; The parameters of the sensor in the middle; The lower atmospheric parameters are set. Start by setting the input and output files. The FLAASH module asks for an image of the spokes brightness, and outputs the reflectivity image. Before we get to the radiation calibration radial brightness Image, here to convert BSQ format images to bill or images of th