全站仪的检验与校正(国外英文资料).docVIP

全站仪的检验与校正(国外英文资料) The inspection and correction of the whole station Inspection and correction of pipe leveler: (1) inspection: (1) loosen the brake screw, turn the instrument so that tube level parallel to A pair of feet screw attachment A, B, screw rotating feet again A, B, make the tube level bubble in the middle. (2) the instrument of vertical shaft rotate 90 °, rotating spiral C another foot again, make the tube level bubble in the middle. (3) the instrument again rotated 90 °, repeat steps (1), (2), until the bubble center four positions. (2) correction: (1) during the inspection, if the air bubbles away from the center of tube level, with the first tube level parallel feet to adjust the screw, the bubble nearer to the center half of the deviation. The remaining half of the screw is adjusted to the center of the bubble by adjusting the screw level with the calibrator. (2) the instrument rotated 180 °, check whether the bubble is centered. If the bubble is still not centered, repeat (1) until the bubble is centered. (3) the instrument rotated 90 °, with a third foot screw to adjust air bubbles in the middle. Repeat the check and calibration steps until the alignment is in any direction and the bubbles are centered. The inspection and correction of the circle level: (1) inspection: If the calibration of the tube level is correct, if the circle level bubble is also centered, no correction is required. (2) correction: If the bubble is not centered, adjust the adjustment screw below the bubble by adjusting the adjusting screw or inner hexagon. For correction, the adjustment screw (1 or 2) that is opposite the direction of the bubble drift should be loosened, then the rest of the correction screw that is then screwed up is centered in the bubble. When bubbles are centered, the tightening force of the three corrective screws should be consistent. The inspection and correction of the telescopes drawing boards: (1) inspection: After the whole instrument, A is selected