主板检测对照代码表（国外英文资料）.docVIP

主板检测对照代码表（国外英文资料） The main board detects the card code synopsis Look-up table required: There are three cases of special code 00 and ff and other starting codes: It has been followed by a series of other code, 00 or ff, and the motherboard is ok. If there is no error in the cmos setup, a non-serious failure will not affect the continuation of the BIOS self check, and the end result will be 00 or ff. The 00 or ff or ff or any other starting code is turned on and the main board is not running. This table is sorted by code value from small to large, and the card is in an uncertain order. Not listed in the undefined code table. 4, for different BIOS (common ami, award, phoenix) with the same code on behalf of the meaning of different, so should make clear what you detect computer belongs to which a type of BIOS, you can refer to your computer using manual, or directly from the motherboard BIOS chip view, also can see directly in the startup screen. The pci slot with a few mainboards appears only in part of the code, but the isa slot has a complete self-checkout code output. And has found a rare original installed motherboard isa slots without code output, while the pci slot with complete code output, therefore, it is recommended that you check the code is not successful, will this double slot card to another slot to try. In addition, the same boards of different pci slot, some slot have send the complete code, such as dell810 only close to the CPU mainboard, according to a pci slot have complete code has been change to 00 or ff, while other pci slot go after 38 does not continue to change. The time required for the reset signal is not necessarily in sync with the pci, so it is possible that isa is starting to code, but the pci reposition light is not out, so pci code stops to start the code. The code synopsis table 00. You will control the INI19 boot load. The processor tests 1, the processor state verifies, and if the test fails, the loop is infinite. The processor reg