stm32编程须知（国外英文资料）.doc

stm32编程须知（国外英文资料） Stm32 programming: Number one: engineering templates are right Second: the program should configure the system clock first Configure the external clock And then were going to start out Third: start coding and loop The declaration of the variable cannot be placed behind the executable, and must be declared in the beginning. For example, to move GPIO_InitTypeDef GPIO_InitStructure to SystemInit (). * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * / / configure system clock and peripherals Void RCC_Configuration (void) { SystemInit (); / / system clock configuration The rcc_apb2periph-clockcmd (RCC_APB2Periph_USART1 | RCC_APB2Periph_GPIOA) | RCC_APB2Periph_GPIOB | RCC_APB2Periph_GPIOC | RCC_APB2Periph_GPIOD | RCC_APB2Periph_GPIOE | RCC_APB2Periph_ADC1 | RCC_APB2Periph_AFIO | RCC_APB2Periph_SPI1, ENABLE); / / rcc_apb2periph.cmd (RCC_APB2Periph_ALL, ENABLE); RCC_APB1PeriphClockCmd (RCC_APB1Periph_TIM4 | RCC_APB1Periph_USART3 | RCC_APB1Periph_TIM2 To ENABLE); (RCC_AHBPeriph_DMA1, ENABLE); } * * * * * * * * * In the PC tube feet, for example An empty input gpio_in_float - an empty input that can be used for KEY recognition, RX1 Take the pull of the GPIO_Mode_IPU -- the input of the resistance inside the IO Take the dropdown and enter GPIO_Mode_IPD -- the internal drop-down resistance input Simulate the input GPIO_Mode_AIN - apply ADC to simulate input, or lower power consumption to save power 5, the output GPIO_Mode_OUT_OD -- IO output 0 to GND, IO output 1, overhang, need external pull resistance to achieve the output high level. When the output is 1, the state of the IO mouth pull up resistors by the higher level, but is open drain output mode, so IO mouth also can be changed by external circuit for low level or the same. You can read the IO input level changes and implement C51s IO bi-directional functions Push pull output GPIO_Mode_OUT_PP - IO output 0 - GND, IO output 1 - VCC, read the input value is unknown The push-pull output GPIO_Mode