豪顿华风机安装幻灯.pptVIP

Fan Selection Fan Performance Curve Fan Designation Arrangement-Single Stage Arrangement-Two Stages Arrangement-B Hub Arrangement-N Hub Blade Models Main bearing assembly-Roller bearing Main bearing assembly-Sleeve bearing Balancing Hydraulic cylinder Diffuser Vibrations Foundation preparation Clean the surface of foundation and keep external materials out. Check the foundation and mark the center line. Foundation preparation-Continued Accurately flat the foundation surface under the shims with chisel or suitable tools, which be sure that there is no clearance between them. Assemble inlet box/diffuserif required If the inlet box and diffuser are divided in pieces they must be assembled with bolts and welded and then, grinded before the installation. The welding is suggested to be finished by dividing subsections and welding alternately to avoid twist/deforming as much as possible. Make an open packing inspection, to be sure that all the parts are available. If some of the rotation parts are protected with an aluminium foil bag, then don’t open this bag before it’s ready to be installed because it is a protection bag to keep the parts dry. Weihai don not open either. Alignment of inlet box Position the inlet box. Before final alignment of the inlet box the main bearing assembly must be installed and align the inlet box with a machine spirit level on the shaft. Before tightening the holding down bolts of main bearing check up the clearance between the four feet and the pedestals. During alignment of inlet box shims must put on the both sides of anchor bolts so that not to deform the flange. If the holes for bolts are too big result in no enough space to accommodate two shims you need realign the inlet box after grouting of anchor bolts. Machining of shims of main bearing Sometimes the shims of main bearing assembly need to be machined at site in case of main bearing and inlet box are delivered from different places. Lift the main bearing assembly into position of inn