2009年普通高等学校招生全国统一考试理综综合能力测试( …(国外英文资料).docVIP

2009年普通高等学校招生全国统一考试理综综合能力测试( …(国外英文资料) Own collection The error can hardly be avoided For reference exchange If there is an error Please! Thanks 2009 National Science comprehensive volume I (physical part) analysis and marking rules 22. (8 points) as shown in the circuit diagram 1, 2, 3, 4, 5, 6 grade connection point The switch is closed That the small bulb does not light; now with a multimeter to check the circuit fault Detection of the need for a power supply, a switch, a small bulb, 3 wires in the circuit and the connection point. (1) in order to detect small bulbs and 3 wires In the connection point L, 2 has connected the case Should use multimeter The block. At the connection point L, 2 at the same time off Should choose the multimeter block. (2) in the switch case If the measured electromotive voltage of 5, 6 between two points close to the power supply Table That may be a fault. (3) the small bulb detachment circuit Write a specific step multimeter to detect whether the fault of the small bulb Suddenly. 22. the circuit comprises a power supply voltage measurement block for general use Disconnect the power supply of the equipment can be used to measure ohmmeter Detection of other equipment should be judged before the resistance resistance gear is normal. 22. standard for evaluation: 8 (1) (2 points (1 points) voltage Fill in V and V to the branch) (1 ohms Fill out the resistance and Omega to the branch) (2) (2) or 5, 6 switch connection point (right one to 2 points) (3) (4) to the ohmmeter; (1 points) The red pen. Check the ohmmeter can work normally; (1 points) The resistance measurement of light bulb Such as infinite resistance That small bulb fault. (2 points) 23. (10) of some students in order to relationship between friction force and inclined angle to explore the objects on slope movement The design of experimental device figure; one end of the plate is placed in a long straight horizontal table The other end frame in a block on the plate; mark A, B 2 B