如何做好地产公司的土建工程师工作？001(国外英文资料).docVIP

如何做好地产公司的土建工程师工作？001(国外英文资料) How to be a qualified civil engineer [transfer] I. knowledge mapping and examination The first step in the construction technology management is to recognize the drawings, because the drawings are the basis of field construction, the drawings should fully understand the intention of the designer, and find out the problems in the drawings. 1. stages of knowledge mapping, procedures are as follows: 1) first rough and thin: first look at the plane, elevation, section, and then look at the details of the practice. 2) before: look at the sample, after the sample. 3) first building after the structure: first look at the building plans, and then look at the structure, to check the architectural drawings and structural drawings of the axis location is consistent, there is no contradiction. 4) first general, later special: first look at the general parts and requirements, and then look at the special parts and requirements. 5) drawings and descriptions of the synthesis: drawings and general instructions and detailed parts of the map should be combined to see, pay attention to drawings and instructions are inconsistent, whether the provisions are clear, the requirements are feasible. 6) civil and installation combination: first look at the construction plan, see the installation diagram, in the installation drawings, some drawings on the building have not expressed, especially for buried parts, leaving holes, the size must be checked clearly. 7) drawings and combined with the actual situation at the same time: familiar with the drawings should be considered in the construction conditions can meet the design requirements, design drawings and site is consistent with the design drawings, the same construction work, specification without contradiction. 8) on the basis of reading a diagram, keep a record while looking at it. 2. stage diagram As far as possible may encounter problems in the construction drawings found in the stage, from the current actu