机械工程师基础知识340 点(二)(国外英文资料).docVIP

机械工程师基础知识340 点(二)(国外英文资料) (two) 1 mechanical common sense 500 ask one: what is called the parallel plane of the projection surface? What is the nature of the projection of this line? Answer: when the line is parallel to the projection surface, it is called the parallel line of the projection surface. The projection of the line is true. 2: any metal sheet has thickness, and the thickness of the plate for what shape and size of the figure is influential? Answer: the shape and size of the unfolded image are affected. 3: how does the surface of a sphere, a ring and a spiral surface unfold on its surface? Answer: its surface is not developable surface. 4: what expansion method is usually applied to the expansion of prisms and cylinders? Answer: general application of parallel line expansion method. 5: tapered tube and cylindrical orthogonal intersection, the intersection lines often use what method? Answer: often use auxiliary plane method to obtain. 6: seek the real length of the curve, which method is used? Answer: multi-purpose expansion method. 7: friction press overload, will only cause what and what slide between, and will not damage the parts Answer: only causes the slide between the flywheel and the friction disc without damaging the parts. 8: open crank press slider travel can be changed by what and what to adjust? Answer: by changing the upper part of the connecting rod eccentric sleeve, the main axis of the center to adjust. 9: in the drawing, extrusion process, due to mold clearance reasons, so what is more stringent requirements of the material? Answer: the thickness of the material tolerance requirements more stringent. 10: blanking, the process of separation of sheet metal can be roughly divided into three stages? Answer: 1: elastic deformation, 2: plastic deformation, 3: cracking separation. 11: the more drawing coefficient, the greater degree of material deformation? Answer: the smaller the drawing coefficient, the greater the degree of deformation of th