机械设计经典填空题 附答案(国外英文资料).docVIP

机械设计经典填空题 附答案(国外英文资料) Second lesson belt drive In 1. belt drives, the three stresses on the belt are stress, stress and stress. The maximum stress equals that it occurs at the allowable stress of the band less than that, which will lead to the band Invalid。 In 2. belt drives, slippage is usually occurring on wheels. At the beginning of the skid, the relation between the tight side tension F1 and the slack side tension F2 is:. 3. when belt drive and gear drive do deceleration work, the belt drive should be arranged in the gear drive. When the belt is driven from the center to the horizontal, it is advisable to place the loose side in the square. In the process of 4. belt transmission in one week, the stress of Belt should be changed, in which the stress changes the maximum, while the stress does not change. 5. belt drive ratio should not be too large, if the transmission ratio is too large, so that the band will reduce the effective tensile force. 6. a V belt transmission, cross sectional area of A=142mm, produced by the tension stress of o = 1.5MPa, Fe=300N effective tension, neglecting the effect of centrifugal force, Fl force and loose tight side tension tension F2 = N and N respectively. 7. to control the proper initial tension is an important condition to ensure the normal operation of belt drive. The initial tension is insufficient, and the initial tension is too large. 8. common belt drive tensioning devices are available. 9. common V belt pulley groove angle with the wheel diameter decreases. 10. when designing the V belt drive, the V belt model is selected. 11. belt drive can not guarantee accurate transmission ratio, the reason is that. 12. belt transmission design criteria for. 13. when designing V belt drive, it is found that V has too many roots and can be used to solve it. 14. belt drive, in the work, because the belt in the belt wheel produces the elastic sliding, this kind of elastic slide avoids. 15. belt drive method can make small wheel angle alpha