ADI AD5421回路供电工业过程控制方案.docx

ADI AD5421回路供电工业过程控制方案 ADI 公司的AD5421是完整的16位4mA-20mA转换器,包括用来给自身和发送器中其它器件供电的稳压器,输出电压从1.8V到12V,漂移为5ppm/℃.器件还包括精密的1.25V和2.5V基准电压源. AD5421采用标准的HART FSK协议通信,串口速率高达20Mbps,主要应用在工业过程控制,4-20mA回路供电发送器以及智能发送器.本文介绍了AD5421主要特性, 功能方框图,和HART调制解调器连接框图以及应用框图.16-Bit, Serial Input, Loop-Powered, 4mA to 20mA DACThe AD5421 is a complete, loop powered, digital to 4mA-to-20mA converter, designed to meet the needs of smart transmitter manufacturers in the Industrial Control industry.It provides a high precision, fully integrated, low cost solution in a compact TSSOP package.The AD5421 includes a regulated voltage output that is used to power itself and other devices in the transmitter. This regulator provides a regulated 1.8V to 12V output voltage. The device also contains precision 1.25V and 2.5V references, The AD5421 thus eliminates the need for a discrete regulator and voltage reference.The AD5421 can be used with standard HART FSK protocol communication circuitry without any degradation in specified performance. The high speed serial interface is capable of operating at 20 Mbps and allows for simple connection to commonly-used microprocessors and microcontrollers via a SPI compatible three-wire interface.The AD5421 is guaranteed monotonic to 16-bits, offers 0.0015% integral nonlinearity, 0.03% offset error and 0.03 % gain error.The AD5421 is available in a 28 lead TSSOP package and is specified over the extended industrial temperature range of –40℃ to +105℃.AD5421主要特性:16-Bit Resolution and MonotonicityPin selectable NAMUR Compliant Ranges4mA to 20mA3.8mA to 21mA3.2mA to 24mANAMUR Compliant ALARM CurrentsDownscale ALARM current = 3.2mAUpscale ALARM Current = 22.8mA/24mA0.05% maximum Total Unadjusted Error (TUE)0.0015% maximum INL Error (15 Bits minimum)5ppm/℃ typ Output Drift350uA maximum Quiescent CurrentFlexible SPI Compatible Serial Digital InterfaceSchmitt Triggered InputsOn-Chip Fault Alerts via FAULT pin or ALARM CurrentLoss of SPI I