冷水机电源检测的6个方面,和常见的八个问题(国外英文资料).docVIP

冷水机电源检测的6个方面,和常见的八个问题(国外英文资料) Inspection of power supply and electrical control instrument system 1) the first check before starting the distribution capacity and unit power match, chooses cable diameter is able to host under maximum working current. 2) check whether the battery system is consistent with the unit, the unit electricity system, three-phase five wire (three phase line, the zero thread, a piece of ground, 380 v + / - 10%). 3) check whether the compressor power lines connect immediately, if there are any loose, tighten again, compressor wiring in twisted torque for 500 kg. The cm. The screw can be loose because of the influence of the main engine on long distance transportation and suspension. Otherwise, it may cause the engine to control the electrical components in the cabinet (e.g. air switches, ac contacts, etc.) and the compressor damage. 4) use a multimeter to check all electrical lines and check if the wiring is properly installed. Use a megabit measurement to make sure there is no short circuit; Check the ground wire is properly installed, the insulation resistance is greater than 2 m Ω; Check whether the power lines meet the capacity requirements. Check whether or not the circuit breaker is installed on the power line of the supply unit. 6) for all wiring and control loop controller NaZhu loop control wiring diagram wiring outside the comprehensive check rear can electricity (such as the crankcase oil heater, compressor electronic protector, circulating water temperature sensors, flow switch targets spreading of wiring, water pump, etc.); Check to see if the terminal bolts are tight and not loose. Check the electrical control meters, whether the electrical appliance is installed correctly and fully, check the outside of the electric control cabinet, especially if the connection is clean and unclutter. 7) checked the above project to control cabinet electricity, power indicator, oil heater began to work at this time, observe whether phase sequen