新款君越GF6(6T40E)的放油螺丝和油位检查螺丝(国外英文资料).docVIP

新款君越GF6(6T40E)的放油螺丝和油位检查螺丝(国外英文资料) The new regal GF6 (6T40E) oil screw and oil level check screw Transmission oil level and status check; This program checks the transmission oil level and checks the oil liquid itself. Warning: only use Dexron? 6? 1VI gearbox oil. Failure to use the proper transmission oil may cause internal damage to the transmission. Note: ensure that the transmission has enough fluid to ensure that the vehicle can be safely started without damaging the transmission. Vehicle flameout and transmission oil temperature in about 20 to 25 ° C (68-77 ° F), will have plenty of oil from the oil hole eduction. Once the vehicle starts up, this ensures that there is enough oil in the reservoir to meet all the parts. No oil foot check procedure 1. Starting engine. Step 2 step on the brake pedal and place the shift bar on each gear, and pause for 3 seconds at each slot. And then put the shift bar back in the car? 6? 1 (P). Make the engine 500-800? 6? At least three times the speed of a revolution? 6? In one minute, the oil foam dissipates and the oil is stable. Loosen the brake pedal. Note: if the transmission oil temperature reading is not the desired temperature, the vehicle cools or runs the vehicle until the transmission oil temperature reaches the appropriate value. If the oil temperature is below the specified range, the following procedure is executed to ensure the temperature of the oil is reached. Drive the vehicle until the oil temperature reaches the specified value. Keep the engine running, and observe the transmission oil temperature through the drivers information center or troubleshooting instrument. 6? 1 (TFT). Warning: when the transmission oil temperature? 6? 1 (TFT) for 85-95 ° C (185-203 ° F), must check the transmission oil level. If the transmission oil temperature is not this temperature, operate the vehicle or keep the fluid in order to cool down. If the oil level is set when the transmission oil temperature exceeds this temperature, i