通信局（站）低压配电系统用电涌保护器.docVIP

信号网络浪涌保护器标准符合性认定 检验实施细则  目 录 1 编制依据及适用范围···························································································· 1 2 引用标准 ·················································································································· 1 3 检验项目及技术要求····························································································· 1 3.1 检验项目及技术要求····················································································· 1 3.2 对各种类型SPD 检测项目········································································· 4 4 检验方法·················································································································· 5 5 抽样 ························································································································· 5 5.1 抽样基数········································································································· 5 5.2 样品数量········································································································· 5 6 质量判定 ················································································································· 5 6.1 信号网络浪涌保护器监督总体的检验项目和质量判定························ 5 6.2 判定准则·········································································································· 5  信号网络浪涌保护器标准符合性认定检验实施细则 编制依据及适用范围 本细则是依据中华人民共和国通信行业标准YD/T1542-2006 《信号网络浪涌保护器技术要求和测试方法》编制。 本细则适用于信号网络用浪涌保护器(包括线路接口避雷器、天馈线避雷器等)的标准符合性认定质量检验。 2 引用标准 GB 5169.11-1997 电工电子产品着火危险 试验方法 成品的灼热丝试验和导则 GB17464-1998 连接器件 连接铜导体线用的螺纹型和无螺纹型夹紧件的安全要求（idt IEC 999:1990） GB/T4942-1993 低压电器外壳防护等级（eqv IEC60947:1988） 3 检验项目及技术要求 3．1 检验项目及技术要求（见表1）。 表1 检验项目及技术要求 序号 项目名称 技术要求 1 外观要求 a) 金属零部件表面应光洁、不应有表面缺陷，镀层外观必须光滑细致，没有斑点、凸起和未镀上的地方。 b) 塑料零部件表面应平整，有光泽，无裂纹、肿胀、疏松、气泡等缺陷。端子、螺帽、插头、插孔应良好。 c) 标志应完整清晰，耐久可靠，内容齐全，且铭牌不应出现移动和任何翘曲现象。 2 最大持续运行电压（不标明Uc不作要求） 最大持续运行电压Uc由产品说明书规定，在此电压和升高20%后再返回此电压时，产品的对地漏电流小于1mA。如产品说明书不标明Uc，则不作要求。 3 对地阻抗 平衡线输入输出端对地阻抗：≥1kΩ；非平衡线不规定具体要求。