金蝶软件操作过程中提示“你当前使用的功能与其他用户有冲突目前无法使用”解决方法.doc.doc

金蝶软件操作过程中提示“你当前使用的功能与其他用户有冲突,目前无法使用!”解决方法金蝶软件操作过程中提示“你当前使用的功能与其他用户有冲突,目前无法使用!”解决方法： ?????? 一般要清除系统的产生的记录。 ?????? 1、操作路线图一：（系统使用状况）??????? ??????? ???? 双击打开系统末级使用状况，清除里面的纪录，如下图： ? ???? ? ?????? 点击工具栏—像皮擦按钮,擦掉，全部清掉。 ? ?????? 2、操作路线图二，（网络控制） ? ??????? 进入： ???????????? ? ????????? 继续进入： ????????? ? ??? 最后，清除记录： ??? ? ?????? 提示消失，可以正常操作了。这里适应金蝶最新版本V12.0，V12.1，如果是以前的版本，请在账套管理里面操作。 ? Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part pla