前反向链路高FER(国外英文资料).docVIP

前反向链路高FER 1, forward link high FER reason analysis If the forward FER is too high, there is not enough forward Eb/Io. The main reasons for the forward link high FER are as follows: the forward service channel is too bad, and the pilot signal is too poor. 1) to the business channel too: if the received power and pilot Ec/Io mobile station is very high, a strong pilot means that the mobile station in the cell coverage, but the forward link of FER is very high, that may be too poor to the business channel. The main reasons are as follows: the reaction speed of forward link power control is too slow, the maximum gain of the traffic channel is too low, and the base station has terminated the pre service channel and pilot pollution. The reaction speed of the forward link power control is too slow: the forward power control is that the base station adjusts the power allocated to each traffic channel, so that each mobile station in different propagation environment obtains sufficient signal energy. The range of adjustment is small, and the fluctuation range of nominal power is suggested to be 3~4dB. In the standard does not give its specific implementation, by the base station equipment manufacturers to design their own algorithms, so each device manufacturers may be different. The base station determines whether to increase the transmit power or reduce the transmitted power by reporting the frame error rate of the forward link by the mobile station. The mobile station report is divided into regular reports and threshold reports. These two reports can exist simultaneously, or they can be used as long as one or two of them are not needed. It is set according to the specific requirements of the operators. If the pilot signal is very strong, but the power allocated to the forward traffic channel is insufficient, the forward power control process may not keep up with the change of the channel. The maximum gain of the service channel is too low: the maximum gain of the service